Finally made something in the shop. Summer outdoor projects, golf, kept me away, but glad to get back to making sawdust.
This is my version of a Japanese tool box.
1/4 sawn white oak with finger joints for assembly.
I recessed a Kumiko panel -"as a no ha"-into the lid.
#SAPFM
1
Repair/re-glue job for neighbor on her "EASTLAKE" BED HEAD BOARD. Significant crack/split in bottom of left leg where side rail drops into slot. All the glue is dried up and leg came off easily. We'll see how it works out? Using hide glue.
#SAPFM
5
The "finish" line is in sight. The hard maple version of the porringer top tea table is ready to apply the finish. The poplar/mdf prototype was very useful in tweaking details.
#SAPFM
2
New project:Small poringer top end table, 2 axis turned cabriolet legs. 1st prototype of leg in poplar: room for lots of improvement, although reasonable 1st attempt.
Time to try again.
#SAPFM
1
3
Shaker standing desk is taking shape. Base completed, upper desk portion has plenty left to do.Sloped writing surface with breadboard ends is next.
#SAPFM
2
5
Stand up desk, my Shaker version, adaptation of Jim Toplin's in Popular Woodworking :Feb 2016 &Christian Becksvoort ' desk in Fine Woodworking 2016. Hard white maple. Photo of the base dry assembled.Legs are tapered on inside surfaces.
1
4
Completed a fun little project. Desk top organizer made with resawn white oak. Based on Dec. 2020 FW cover project by Michael Pekovich.I am on a box joint kick instead of dovetails. #SAPFM
Start of new small project.From Fine Woodworking - desktop organizer-MichaelPekovich-resawn white oak - glue up for the organizer.#SAPFM
1
4
Completed a Japanese tool box in walnut with antique oil finish. Lots of fun to build and it will replace "shoe boxes" for carving tools, chisels and other hand tools. #SAPFM
1
3
Doug Moulder retweeted
I like my boxes with finger/box joints. This is going to be a Japanese tool box, made out of resawn walnut: 5/16th " thick.13" × 18" × 9" deep. The walnut top/lid is next.#SAPFM
I like my boxes with finger/box joints. This is going to be a Japanese tool box, made out of resawn walnut: 5/16th " thick.13" × 18" × 9" deep. The walnut top/lid is next.#SAPFM
Shaker Berry Boxes, completed. Made a batch,7 total. Normally they would have been clear white pine, but I had scraps of "genuine" mahogany, just big enough to resaw into 3/16" box material. Finger:box: joints and copper rivets to attach the bent maple handles.#SAPFM
When trying to bend kiln dried cherry for basket handles, rip plenty of pieces! The failure rate for me is growing. #SAPFM – at Elyria, OH
2
Bending 1/8 th in. thick- kiln dried maple strips- soaked in 180 degree water - around form-to fit Shaker Berry boxes.#SAPFM – at Elyria, OH
3
Shaker Berry Basket progress, baskets completed. Built forming mold to bend hot water soaked basket handles over. Going to try both cherry and gard maple strips. See which bends better?#SAPFM – at Elyria, OH





























