.AI

My first Digital Timepiece constructed entirely using PCBs. Rate my concept & share your thoughts. 😄 GitHub link: github.com/0101shift/Project…

Rate my badge / souvenir! 😁

What's your best rework till date??? Let me start, Cross connecting panasonic push button using enamel wire. 💪🏽

Take note everyone... Whenever working around custom LED matrix display, be aware about this LED Ghosting scenario. It saves lot of debug time. Anyone faced this issue before?

After countless hrs of redesig, OAK V1 talks back for the first time. 🤩 HELLO WORLD! A lot of features added to this variant, will test one by one. PS: NGL, @JLCPCB really did a great job on that BGA and LGA assembly! More info: github.com/0101shift/Project…

Yay!!! Got my hands on a multicolour PCB for the first time. TBH, the graphics look great, but soldering is painful due to the colour gradients... Anyone tried multicolour PCB before??? @blind_via @MakeAugusta @DIY_With_Hardik

DO NOT SPLIT GROUND PLANE unless it is an ISOLATED SUPPLY/INTERFACE!!!

Is there a way to run these LEDs on 3V? They are so pretty to avoid them in PCB badges... @blind_via @MakeAugusta

After the final copper pour, i was going for a review. Then In few areas i found slight reference mismatch. I know the signal shown here is a low-speed signal, but in general, do i need to review layout at this level? First of all, does this really matter in terms of SI? 👀

linkedin.com/posts/anand-m-0… SPICEphobia anyone!? 😂

This is what happens when you try avoiding time-step error by changing the min. time-step to the least in LTSpice. I had never imagined that a small 100ms simulation can generate this much hefty data! LTSpice simulations are always fun! PS: IT, can i get my storage upgraded🤣