Nick Rich (@NickvRich) header
Nick Rich (@NickvRich) profile picture

Christian. Husband and father of two girls. Custom farming, spraying, strip tillage, and have a small business called NV Innovations.

Eastern Iowa
Joined May 2014
Photo by Nick Rich (@NickvRich)Photo by Nick Rich (@NickvRich)Photo by Nick Rich (@NickvRich)Photo by Nick Rich (@NickvRich)Photo by Nick Rich (@NickvRich)Photo by Nick Rich (@NickvRich)Photo by Nick Rich (@NickvRich)Photo by Nick Rich (@NickvRich)Photo by Nick Rich (@NickvRich)Photo by Nick Rich (@NickvRich)
Replying to @CDeklotz
@CDeklotz 2500 acres on 12 rows. Pretty good for rock points. Designed with a lot of wear material to burn off.
26
3,330
Almost time for last call.
1
1
1
16
934
My version of a strip till knife for conventional toolbars. Just got a few samples running for this fall. Foot angles and point width similar to a B33 mole, just a lot more meat to wear though. Freeze proof and tall cutting edge so the knife runs clean. Can’t make the knife any narrower due to wall thickness limitations of the casting.
1
30
2,405
Conditions are 🫤 but we are stripping.
3
4
34
5,475
The reality of 3D printing. You’ll probably have to work on your printer at some point. This is true of the 5 different models I’ve owned since 2020. My 7 Bambu X1E printers have printed 1000s of parts for me so I can’t complain.
3
491
Last y drop field 🤞
1
20
2,223
About time to pull the drops off.
3
18
2,331
One more fill for the day.
1
2
25
4,588
Flex Dropping as the storm rolls in.
1
1
23
4,860
Flex Drop check.
2
13
3,861
Nicest field yet.
4
4
23
3,367
Dropping the N.
2
28
2,757
AMS Enlist MSO.
2
1
612
Evening chores.
1
494
Not terrible.
1
24
2,821
132 ft of drops for 22” corn. 👌
2
3
35
5,905
Some more Flex Drop parts ready to deliver tomorrow.
7
801
The challenges of 3d printing nylon filaments. The print on the right is junk due to moisture in the filament. Foggy and rougher texture from the moisture. This will also make the part brittle. Filament dryer died after I started the print. When everything is dialed in these carbon fiber nylon parts are amazing.
2
5
1,824
Liberty/Enlist see and spray prepping. Back to the old days of using the AIXR.
2
792
Looking ok. 👍
3
1
49
3,965
Selling my ZML toolbar. Never been used. Was going to build a 12 row 3pt strip till rig but went a different direction. Nice bar. DM me if interested.
4
6
10
6,436