Hard to believe these 2 photos were taken in nearly the same place! March22- Nov25.
Kudos to @james_cant_ for ripping the one ski 💪
Replying to @PJScoff @JamesPreuss
Was fairly straight forward for the box, auger & back steps were more complicated.
Are there any tractor hydraulic gurus that can help diagnose this noise?
Replaced hyd pump, valves & fittings but no luck.
Can see bubbles in oil tank so must be getting air in system somewhere, hyd’s eventually non operational.
Dealer has raised with CNH support but no luck
Replying to @lubin_stringer
Hope you're right mate, our probes are showing showing similar starting moisture to 2022. Red line was medic last year, blue wheat.
Any ISOBUS/ Ag tech gurus able to help?
We’re setting up a new (to us) air cart & would like to run it iso.
However we only have a poxy little intelliview 3 screen in current tractor.
Options are run it through the IV3, upgrade to an IV4, use the cart screen or something else?
Replying to @mattrohde8 @DaveyJohn_676
Nothings changed & that might’ve be the problem! Upgraded firmware to 10.18 and all good.
I was sure we’d used x-fill since the frequency changed but perhaps not.
Only a couple paddocks in a hollow about 12kms from our tower that we need it.
Thanks for your help anyway 👍
Can any Trimble GPS experts help here.. can’t get x-fill to work, if we lose our tower for a minute it goes just into float.
Settings are same as Pro700 & that works fine. Used to be a little ((X)) in top left corner but it’s disappeared 🤷♂️
Replying to @tomcroser @Millie_Moore22
I've posted this before but these are NDVI & Yeild screenshots from an on farm demonstration 2022.
Fallow areas had some soil cover (hay previously) and 21/22 summer was probably wettest on record.
Weeds were mostly heliotrope & melons, summer crop was a multi mix














