(Former) Makers of electronics and gadgets. Account inactive, no longer maintained. @AndonRT is my personal account
Joined September 2015
- Tweets450
- Following40
- Followers48
- Likes103
Pinned Tweet
So, with that, I'm going to hang up my hat here. This will likely be the final tweets from this account. If you want to follow me personally, the account is @AndonRT - But don't expect much, I'm not super active on Twitter.
With that - So long, and thanks for all the fish!
So, it's been a year and change since I officially announced a hiatus.
Turns out, it's permanent. The stress, paperwork, and everything else that went into electronics was a lot, and what I got out of it was... not.
(1/3)
Can't wait!
If you thought yesterday's blog post was a thing of pure wonderment, you should see todays. Don't say we never treat you: raspberrypi.org/blog/trick-o…
Sad to not be able to visit the NYC Maker Faire as planned, but some things came up and I am unable to attend. Perhaps next year! I did hope everyone there has a fantastic time.
Phoenixborn Technologies retweeted
Proof that @PaintYourDragon is a sorcerer -- here he is ray casting a "3D" labyrinth on the @adafruit HalloWing Feather M0 Express learn.adafruit.com/hallowing…
Got the newest R2 from @PCBWayOfficial - Assembled it and everything's great. Except the SD slot, but that's not a surprise. Those things are hard to hand solder.
There seems to be a minor bug in the code with not restoring the mode after a hard reset, I'll have to poke at that.
So, after putting together the Mini R2, I've found the following issues:
1 - Power LED connected to an input-only pin. Oops!
2 - No reverse voltage protection.
3 - Bad reads for measuring battery when switched off (Running via FTDI or otherwise)
4 - Several silkscreen issues
The third was solved with a pull-down resistor. Finding a free spot for that was interesting. Squeezed betweeen two buttons. Being a four-layer board, though, it wasn't difficult to route.
PCBs acquired this afternoon from @PCBWayOfficial - The SD slot was problematic, but third time is the charm.
Only issue I can see so far is that I didn't pay enough attention. Power LED is connected to A7 - Which is read-only. Oops!
I have to say, new buttons are super great.
Looking forward to getting my PCBs from @PCBWayOfficial tomorrow. Hopefully the prototype of the Mini R2 works great.
Oooh, my PCBs are 47% complete, I expect @PCBWayOfficial will be sending them out soon. I'm impatient to get my hands on them.
DigiBadge Mini R2 board has been sent off to @PCBWayOfficial to be manufactured, and the parts that I don't have are on order from @digikey - I'm getting antsy waiting, and it's only been a day.
