Stephen Atchison retweeted
The claim that Iran was planning on attacking the U.S. or U.S. Forces, whether preventively or preemptively, is a sheer and utter lie.
The sole purpose of that lie is to justify Operation Epic Mistake, a misadventure engineered by Israel and paid for by ordinary Americans.
Stephen Atchison retweeted
Israel is bombing Iranian historical monuments dating as far back as the 14th century. Multiple UNESCO World Heritage Sites have been struck.
It's natural that a regime that won't last a century hates nations with ancient pasts. But where's UNESCO? Its silence is unacceptable.
Stephen Atchison retweeted
A brief word today at the end of the fifth horrific week of Trump 2.0. We are witnessing the transformation of our democracy into a dictatorship (or, as Trump enjoyed promoting this week, a monarchy). robertreich.substack.com/p/f…
Stephen Atchison retweeted
Canada is a sovereign country. We have free universal healthcare, a longer life expectancy than the USA & we don’t live in fear of getting shot up here. We will never be a part of the USA you fucking deranged, sociopathic dumbfuck. SO SHUT THE FUCK UP!
Removal and replacement of the original grip ring is necessary, because due to age, the original grip ring material is like sand paper. It will either remove or chew up laserdisc labels when a disc is stopped.
1
49
Gently lifting the track arm off of the gears, so the pinion can be decoupled from the gear movement, then adjusted one click at a time until the motor will cut out before the slider arm strikes the end point of motion.
138
The initial condition of this player, LD-9200D, was that the slider motor would not stop. Meaning the pinion potentiometer, and VR8 were out of alignment.
58
The slider mechanism for LD-9200D made use of a pinion potentiometer to set the stopping point, the inside position detection. Variable resistor, VR 8, on the pre-processing board, then finely adjust that position to where it can read a laserdisc.
39
CAV discs spin at a constant speed of 1800 RPM. So no matter when the disc is stopped during playback, the grip ring will be stopping the disc from a maximum speed. So signs of a bad grip ring will be more obvious when spinning CAV laserdiscs.
1
56
Removal of the original grip ring from LD-8200D. The symptom of an old grip ring is that it can remove laserdisc labels or scratch them up from a stopping grip that is as rough as sandpaper. Replacement Grip Ring is VEB1008.
2
25
Some small adhesive felt pads added to the older laserdisc disc table can add an extra measure of scratch protection for discs.
1
19
If you switch from Digital to Analog sound on a Digital Audio laserdisc, you might notice the sound gets thinner. In particular, the downgrade will be more noticeable when music is playing.
24
The remote control, CU-LD0001 for Pioneer LD-9200D, an early Digital Sound laserdisc player released in May 1986. This remote did not feature an Analog/Digital button.
1
30
Stephen Atchison retweeted
#InsideMyEasterEgg is probably something that would get me a visit to the vet
Stephen Atchison retweeted
#AWorkplaceIsNotFor smiling—you don’t want to give your boss the wrong idea




















