Replying to @DrKnowItAll16 @GoingBallistic5
Good afternoon, I believe that the robot is doing the reverse work. He needs to take the part from the red box and install it in the slots, and he pulls it out of the slots and puts it in the box) What do you think?
1
1
Do you think @Tesla will appear on Mars or in the CIS countries sooner?
youtu.be/Jnfj21ok8uM
#LightshowRus #Lightshow
Replying to @ajtourville
I'm still concerned about the "three cells" problem
On the module, one edge is completely filled with cells (6), and on the other only 3 cells from the group.
Maybe I don't understand something) Can someone explain to me why this is so?
2
3
Replying to @ingineerix
I'm waiting for even more content)
Do you know what's on the other side? Are there temperature sensors?
Thank you for what you are doing
Replying to @ajtourville @ingineerix
I colored the cells according to their groups (connected in parallel by 6 cells), and it turns out that there is a divided group (green). What are the advantages of this?
I see a flaw in the complexity of the connection.
Replying to @SawyerMerritt
@live_munro @ajtourville what do you think will be the benefits of switching to a different type of stator winding?
0:14
1
4
In the photo where the box uses technology with a bend inwards, but the old covers (with a high wall), which is why you can see the ring marked with black arrows 1,2
2
Replying to @ajtourville @FuturamaKing
A theory that can describe it.
The cell in the video is of the same design as the presentation (bent outward) 1
Poster in Berlin is a new cell (bent inwards and reduced the height of the lid wall) 2
1
2
How tight should the seam be?
Perhaps there is a decrease in the thickness of the metal on the lid, which will be a weak spot when internal pressure appears.
2
Replying to @ajtourville
I like the option suggested (@xdreamcoding) I added a copper plate and a rivet (orange) to the circuit. I believe that the copper plate will be engaged between the case and the lid.
1
3
Each cell (group) must be connected by two contacts (+ and -) to the BMS controller. On the model, this is not present on the extreme elements and at the place of separation of the boards.
For example, the MS Plaid board is the connection point of different BMS controllers.
1
Replying to @ajtourville @veimmone @Tesla @elonmusk @baglino @LimitingThe @MunroAssociates @live_munro
In half of the modules, the current will flow in the other direction, which means that you need to change the connection of the BMS board or change the mounting side.
1
1
If you make the number of cells even (35 or 36), then you can use similar types of plates for ease of connection
1
2
Why did you refuse to use a whole number of assemblies in the module (35 or 36)? Instead, 3 cells were added (6*35+3 )
Using an additional 3 cells leads to connection problems.
1
1







































